Basic Installation Procedures for the Entrega USB to Parallel Printer Converter

New Installation:

1. Turn off your printer and computer.  Ensure that the Entrega USB to Parallel Printer Converter is NOT plugged into your computer.  Turn your computer on and wait for it to complete the boot up process.
2. Once the boot up is complete, insert the installation diskette.
3. Turn your printer on.   
4. Plug the converter into your printer.
5. Plug the USB cable into the converter.  Plug the converter into your USB port. Windows will attempt to install your converter software automatically when you connect it to your computer by launching the New Hardware Wizard.   Important, if you are running Windows 95, when prompted for drivers you must change the directory d:\win95 to a:\.   For Windows 98 you must change to your directory to a:\win98\.
6. The LED will turn red indicating that the converter has been connected.  Remove the floppy diskette from the computer after the drivers have been loaded.
7. Reboot the computer and follow the instructions for adding a printer, which were provided by your printer manufacturer.

Congratulations you are almost complete with your USB to Parallel installation.   Please proceed to ensure your printer/USB installation was successful.

Double-check your converter installation  

1. On the desktop, right click "My Computer" 
2. Click Printer 
3. Right on your newly installed printer (Printer Name) 
4. Click Properties 
5. Click Details as shown below
6. The following should read "LPTUSB1 (Your Printer Name)
 
Congratulations you have successfully installed your Entrega USB-Parallel Converter. 

If Installation was not successful Overwriting the Previous Installation Sometimes the regular installation process won't complete itself.  If this is the case, please follow the steps below:

1. Unplug the Entrega USB to Parallel Printer Converter from the computer.
2. Insert the installation diskette in your A: drive.  
3. Click Start; click Run, then type A:\ETIPARUN.EXE; click O.K.  
4. Reboot the computer when prompted to do so by the Cleanup application.    
5. Go to Section 2.1/New Installation and reinstall this software.





